Bus Fault Injection Board U100 1 Terminal block (2-pin) Switches

1 Terminal block (2-pin) Switches 4 DIP switches Dimensions (L x W x H) 108 x 82 x 33 mm Weight 185 g Operating temperature -20 to 70 °C Enclosure Aluminum profile Protection IP20 Placement Table (adhesive pads included) DIN-rail mount (see Ordering Information)

A popular addition to the family of CAN data loggers

TE MATEnet female to DUSB9 female cable

symbol files

RS232) USB Host: 1 SD Card: 1 Linux Console: 1 (Version as USB or RS232) Cloud: Prepared for use with cloud providers such as IBM Watson I/O Interfaces DI 24V: 16 (data galvanically decoupled) A/B Encoder 2 (alternate functions – depending on used A/B-Encoder) High-speed Counter 2 (alternate functions – depending on used High-speed Counter) DO 24 VDC

Bus Fault Injection Board U100 1 Terminal block (2-pin) SwitchesAllows the user to inject faults into a physical layer of a differential network The board can simulate errors: a wrong termination resistor, open shorted CAN_H or CAN_L to Gnd Vdd, disconnected Gnd or Vdd or Shield signal. The fault injector board is suitable for CAN, CAN FD, FlexRay, RS 485, and LIN buses. The Board has two sides left and right. There are two D SUB9F connectors wired 1: 1 at each side. The switches for fault injection are placed